Give us a call. (607) 288-2116 10am - 4pm EST Mon. - Fri. Text and Email is the best way to reach us.
What bow do you recommend? We do recommended certain bows. The Bolt Shredder, Bear Desire XL, M48 Hell Hawk and the Man Kung MK-TCS2G Alligatorall share the same frame andwork with our products straight out of the box! You do not need to remove or modify the front sight! They are solid smooth functioning bows with standard tactical accessory rails top and bottom. In our evaluation they are most likely the best bang for your buck.
Are you getting more in stock? Absolutely! Keep watch on the available quantity. We tend to restock after we sell out of an item. Thanks for being patient.
Do I absoulty need to remove the front sight? We recommend removing the front sight because on most bows this is necessary. We have not tested our bolts on every single pistol crossbow out there today so, if you are not sure you have to remove the stock front sight you should perform the quarter test. Do this by sliding a Quarter down the rails if the Quarter hits anything passing through the front sight then you must remove it.
Why don't I get good flight? - If you get less than desired flight. First, make sure you are using a 80lb pistol crossbow that is self-cocking. Second, the sight must be removed from the end of the rails or modified to accommodate the width of the bolts. Third, refer to the "What tips?" tab of this site when selecting broadheads. Last, avoid shooting your bolts at hard unforgiving targets that bend the shaft. JaXce Bolts deliver a lot of kinetic energy and can deform if they impact something too hard. A bent shaft from such an impact will not produce accurate flight.
Can I replace the vanes? - Our bolts use some of the best vanes on the market and are attached with a high performance adhesive. However, if the bolts are buried into a target up to the vanes, damage to the vanes may occur. Because JaXce Bolts are made with a one piece shaft like traditional arrows, the vanes may be replaced. If the vanes are to be replaced, care must be taken to remove the old vanes and to completely clean the shaft before new vanes can be attached.